Self-Diagnosis - DeLonghi AN Series Instructions For Use Manual

20
25
24
Inserting or replacing the batteries
• Remove the cover on the rear of the remote control;
• Remove the old batteries, if present.
• Correctly insert two new L03 "AAA" 1,5V batteries (see the
instructions inside the battery compartment);
• Replace the cover.
If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in
accordance with current legislation as they are
harmful to the environment. Do not mix old and new
batteries. Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries. Do not dispose
of batteries in fire. Batteries may explode or leak. If the
remote control will not be used for a certain length of
time, remove the batteries.
Note: This equipment has been tested and found to
•
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
• This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display.
IF...IS DISPLAYED,
"Low Temperature"
...MEANS: room temperature is too low
21
22
23
IF...IS DISPLAYED,
"High Temperature"
...MEANS: room temperature is too high
10
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help. Changes or modifications
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
• This Class B digital apparatus complies with Canadian
CAN ICES-3 (B) / NMB-3 (B).
Turning the appliance ON
Plug the appliance into the mains.
Press the ON/OFF button of the remote control (20) (when
turned on, the air conditioner starts operating in the same mode
as when last turned off).
Press the MODE button (22) button to select the required mode:
AIR CONDITIONING (COOLING) - DEHUMIDIFYING - FAN ONLY
The light corresponding to the selected mode lights up on the
control panel.
For air conditioning/dehumidifying/fan only settings and
programming the timer see the relative paragraph.
...MEANS: contact your local customer service
IF...IS DISPLAYED,
"Probe Failure"
(sensor damaged)