Table of Contents
Advertisement
Assembly Instructions
For the installer
and kitchen expert!
Important installation
notes
The connection diagramm is
located on the rear panel of the
appliance.
~
L
220-240V
52
Properly dispose of packaging materials.
Do not use oven door handle for
transporting or handling the unit during
installation.
WARNING: Connection and first start of the
appliance may only be performed by an
authorised specialist.
Connection must be made using an
H 0 5 R R - F 3 G 1,5 mains connection cable.
Rated consumption, rated voltage and type
no. of the appliance:
See appliance nameplate behind the oven door
to the left beneath the side edge of the oven.
The unit's nameplate is located at on the
sidewall of the unit.
Electrical safety of the appliance can be ensured
only if the equipment earth in the building
installation has been installed according to
regulations.
On the installation side a separating device shall
be provided. Any switch with a contact gap
exceeding 3 mm may be considered a separating
device. Other examples are LS switches, fuses
and contactors.
In the case of repairs interrupt all power
N
connections to the unit.
The properly installed appliance must be covered
on all sides in such a fashion that not even
components with rough insulation are exposed to
the touch.
The cover must be removable with tools only.
Hide quick links:
Advertisement
Table of Contents
