Hilti SF 6-A22 Original Operating Instructions page 20

3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a hand-held cordless drill / driver. It is designed for drilling in steel, wood, plastic,
cellular concrete and masonry and for driving and removing screws.
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series with these batteries.
3.3 Items supplied
Drill / driver, side handle, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
3.4 Li-ion battery state of charge display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting
section.
14 English
1
@
;
=
%
&
(
)
+
§
/
:
∙
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
The battery has overheated.
The power tool has overheated or is overloaded.
Pivotable side handle
Chuck (keyless chuck / hex bit holder)
Torque and operating mode selector ring
Two-speed gear selector switch
Forward / reverse selector switch with safety
lock
Control switch (with electronic speed control)
Vibration-absorbing grip
Illumination
Belt hook (optional)
Battery
Charge state and fault display (Li-ion battery)
Release button with additional function
(charge state display activation)
2118917
*2118917*