Cisco SPA100 Series Manual page 2

- DHCP — Press 0 to activate DHCP (Dynamic Host Control Protocol) which sets IP
addresses dynamically.
-Static IP — Press 1 to activate static IP addressing. You will have to provide a static IP
address, default gateway address, and subnet mask later via IVR.
-PPPoE — Press 2 to active PPPoE (Point to Point Protocol over Ethernet). You will have
to provide the IP addresses provided by your Internet service provider later via IVR.
• Check Internet IP address (INTERNET Port) — Press 110 to check the IP address of the
WAN port.
• Set Static IP Address (INTERNET Port) — Press 111 to set the static IP address. Then
enter the desired static IP address by using the numbers on the telephone key pad. Use
the Star key (*) for decimal points.
Note: This option is only available after you choose Static IP as the Internet connection
type.
• Check Network Mask — Press 120 to check the actual subnet mask.
• Set Network Mask — Press 121 to set the network mask. Then enter the subnet mask
using the numbers of the telephone key pad. Use the Star key (*) for decimal points.
• Check Gateway IP Address — Press 130 to check the actual IP address for the default
gateway.
• Set Gateway IP Address — Press 131 to set the IP address for the default gateway. Then
enter the gateway IP address using the numbers of the telephone key pad. Use the Star
key (*) for decimal points.
• Check MAC Address — Press 140 to check the MAC address of the adapter.
• Check Firmware Version — Press 150 to check the actual firmware version of the
adapter.
• Check Primary DNS Server Setting — Press 160 to check the actual settings for DNS
(Domain Name System).
• Set Primary DNS Server — Press 161 to set the primary DNS server. Then enter the IP
address of the primary DNS server using the numbers of the telephone key pad. Use the
Star key (*) for decimal points.
• Check Internet Web Server Port — Press 170 to check the actual port number the
INTERNET port is using.
• Check LAN IP Address (ETHERNET port) — This is only available for the SPA122. Press
210 to check the IP address of the ETHERNET port.
• Announce Line 1 SIP Transport — Press 1910 to check the actual transport protocol for
SIP (Session Initiation Protocol) of line 1.
• Set Line 1 SIP Transport — Press 1911 to set the transport protocol used in line 1 for SIP.
The options are:
- UDP — Press 0 to set UDP as the transport protocol (User Datagram Protocol).