Apex Digital iCH Auto Instruction Manual page 13

iCH Auto/ English
NOTE: The minimum pressure is only to be prescribed by a doctor.
(7) Initial Pressure (only APAP mode)
"MENU"
Press
the current pressure setting displayed in cmH
the provider, a respiratory therapist or doctor.
NOTE: The initial pressure is only to be prescribed by a doctor.
(8) PVA (Pressure Variation Algorithm)
"MENU"
Press
the provider, a respiratory therapist or physician. The PVA function delivers pressure relief upon
exhalation to improve comfort. If the PVA function is enabled, press
adjust the comfort level. There are 3 adjustable levels of pressure relief that you feel while
exhalation. Level 1 provides small pressure variation; and level 3 provides higher pressure
variation.
(9) Low Pressure Auto Off (only CPAP mode)
"MENU"
Press
setting is enabled and the device will be automatically turned off while detecting a large leak for
3 minutes. This setting is adjustable only by the provider, a respiratory therapist or physician.
(10) Compliance Meter
Press "MENU"
therapy hours for the device. The compliance meter should be re-set only by the provider, a
respiratory therapist or by a doctor.
(11) Alarm
Press "MENU"
the alarm on or off. When the alarm is turned on, the audible alarm will activate with warning
messages shown on the LCD display. Set alarm off to mute the audible alarm.
(12) Clock Alarm
"MENU"
Press
set the clock alarm on or off. When the clock alarm is set on, the display will show the time on
the left side. Press
activated, press the start/standby button to mute the audible alarm.
(13) Clock
"MENU"
Press
current time.
NOTE: If you set a new time that occurs in the past then the "Invalid Data" which does not
(14) Turning off the Device
Remove the power cord from the electrical outlet, and disconnect power cord from the power
socket on the right side of the device.
NOTE: Once the setting is confirmed, press the
[Init.
button to select
[c
button to select
[LOW P on/off]
button to select
button to select the
button to select the
button to select the
"UP" "DOWN"
or
button to select the
exist for this new period would be erased.
automatically go back to standby without saving the modification if no action is
taken in 20 seconds.
XX.XcmH O] [Init.
or
2
O or hPa unit. Initial pressure is adjustable only by
2
on/off]
menu, you can view if the PVA function is enabled by
menu, you can view if the Low Pressure Auto Off
[CM XXXX.X hr] menu. The compliance meter records the total
[Alarm on/off] menu, and press
[Clock Alarm on/off]
menu and press
button to set the time to wake you up. Once the clock alarm is
[Clock XX:XX]
menu, press
"MENU"
XX.XhPa]
menu. Here you can view
"UP" "DOWN"
or
"UP" or "DOWN"
"UP" "DOWN"
or
"UP" "DOWN"
or button to set the
button. Otherwise, the device will
10
button to
button to set
button to