Absaar ATEK 4000 Manual page 8

B. Pre-charge, constant current & constant voltage charging: clamp the output terminal to the ba ery to iden fy 6V
or 12V ba ery; for 6V ba ery, it will start charging in 6V/slow mode immediately; for 12V ba ery, it enters 12V/slow
mode by default; you can press the MODE bu on to switch among the three modes sequen ally(Slow/Fast/Low
Temp), each me you press the bu on, the backlight is turned on for 10 seconds; the display effect is shown in Fig. 9;
C. Float charge: enter the float charging state, the ba ery icon shows full, and the real- me voltage and FUL
characters display alternately at 1Hz frequency.
bu on; no mode selec on is possible during the float charge, as shown in Fig. 10 below:
D. Power-down memory: in the charging process, unplug the power plug or in case of power outage, the product will
save the original charging mode as long as the ba ery voltage exceeds 5V; the LCD
con nue to charge in the original state;
E. Charging completes: unplug the power plug, and then remove the clips from the ba ery.
-MSA International- 5, rue bommel ZAE Robert Steichen L-4970 Hautcharage LUXEMBURG
Fig. 9
Display
alternately
at 1Hz
Fig. 10
the maximum memory me is 12 hours; when the power resumes, it will
www.absaar.com
8
ENG
but