Related Manuals for Absaar ATEK 4000
Summary of Contents for Absaar ATEK 4000
- Page 1 ATEK 4000 6/12V 4Amp Smart Charger with LCD Read this material before using this product. Failure to do so can result in serious injury. SAVE THIS MANUAL...
- Page 2 IP rating IP65 1. Product Introduc on ATEK 4000 is a smart charger based on the PWM high frequency switching ower supply (AC-DC) technology and MCU (with 12bit ADC) control, featuring high efficiency, low loss, small size, light weight, LCD display interface, and complete protection function.
- Page 3 Appearance and LCD Diagram 1) Product structure Fig. 1 LCD diagramm A : Power input 220vlt E : Mode button D: Top Shell H: LCD F : DEL power (green) G: Fault DEL (red) B : Output : red: Positive C : Bottom shell Black : Négative 2) Schéma LCD...
- Page 4 Charging Features and Electrical Parameters This product provides a 4-stage charging mode: pre-charge, constant current, constant voltage, and float charge, and the features are as follows: Pre-charge: iden fy the ba ery voltage before charging; if the ba ery voltage is lower than the reference voltage, the ba ery will be pre-charged in order to avoid damage to the ba ery.
- Page 5 2) Charging mode: iden fy 6V/12V ba eries automa cally; for 6V ba eries, only 6V/1A SLOW mode is available; for 12V ba eries, three charging modes are available, as follows: 1A /SLOW charging mode (default) 12V 1A /SLOW charging mode 12V 4A /FAST charging mode 12V 4A /LOW TEMP...
- Page 6 ii) 12V: When the ba ery voltage is between 7.4V and 10V. The charger will work at 12V/Slow mode. Press the A er charger the ba ery by 2 minutes, if bat In these 2 cases, please press the bu on to detect/check the ba ery status and start the charging process again. need to disconnect the AC power and ba ery cable clamp Keep charging the ba ery 4 hours (6V mode)/9 hours (12V mode) and the ba ery voltage is s ll below the correct level...
- Page 7 Fig.5 and Fig. 6: 6V/ 12V LCD charging block diagram Precau ons and Opera ng Instruc ons 1) Precau ons: a. The supply voltage of the product is 220~240VAC; please make sure that the mains voltage meets the specifica ons of the product before using; b.
- Page 8 12 hours; when the power resumes, it will con nue to charge in the original state; E. Charging completes: unplug the power plug, and then remove the clips from the ba ery. www.absaar.com -MSA International- 5, rue bommel ZAE Robert Steichen L-4970 Hautcharage LUXEMBURG...
Need help?
Do you have a question about the ATEK 4000 and is the answer not in the manual?
Questions and answers