Table of Contents
Advertisement
ENG
ii) 12V: When the ba ery voltage is between 7.4V and 10V. The charger will work at 12V/Slow mode. Press the
A er charger the ba ery by 2 minutes, if bat
In these 2 cases, please press the bu on to detect/check the ba ery status and start the charging process again.
need to disconnect the AC power and ba ery cable clamp
Keep charging the ba ery 4 hours (6V mode)/9 hours (12V mode) and the ba ery voltage is s ll below the correct
level
In this case, you must to disconnect the ba ery cable clamp, or
need to disconnect the power.
Please refer to below Fig. 5 and Fig.6.
Fig. 5: 6V LCD charging block diagram
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ATEK 4000 and is the answer not in the manual?