How To Tell If Water Is In Use; If Continuous Leak Is Repaired; If Intermittent Leak Is Repaired - Neptune Technology ProCoder R900i Installation And Maintenance Manual

How to Tell if Water is in Use

To determine if water is in use, complete the following steps:
1. View the mechanical sweep hand.
2. Determine the following conditions. If the sweep hand is:
l
l
l
l

If Continuous Leak is Repaired

If you find and repair a continuous leak, complete the following steps:
1. Use no water for at least 15 minutes.
2. Check the sweep hand.
If the sweep hand is not moving, there is no longer a continuous leak.

If Intermittent Leak is Repaired

If you find and repair an intermittent leak, check the sweep hand after at least 24 hours.
If the sweep hand is not moving, there is no longer an intermittent leak.
ProCoder™)R900 ™ Installation and Maintenance Guide
i
Moving slowly in a clockwise direction, water is running very slowly
Moving quickly, water is running
Not moving, water is not in use
Moving in a counter-clockwise direction, backflow is occurring
Chapter 3: Reading the ProCoder™)R900i™
9