Control Guide - Panasonic SA-XR25 Operating Instructions Manual

Control guide

Main unit
[% DIGITAL EX, % DIGITAL, % PL2 2 ,
DTS 96/24, DTS-ES, DTS, NEO:6] (
[% DIGITAL EX, % DIGITAL, % PL2 2 , DTS-ES,
DTS, NEO:6] (
SA-XR25
Light to indicate the source's input signal and decoding format
used.
% DIGITAL EX: Dolby Digital Surround EX sources
% DIGITAL: Dolby Digital sources
% PL2 2 : Dolby Pro Logic 2 decoder is being used
DTS 96/24: DTS 96/24 sources (
DTS-ES: DTS-ES discrete or matrix sources
DTS: DTS sources
NEO:6: NEO:6 matrix decoder is being used
[POWER 8]
Press to switch the unit from on to standby mode or vice
versa.
In standby mode, the unit is still consuming a small amount of
power.
Standby indicator [^]
When the unit is connected to the AC mains supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
Remote control signal sensor
Display
[SLEEP]
Sleep timer indicator.
[˜, TUNED, ST, MONO]
Radio indicators
˜: Flashes or lights during presetting.
TUNED: A station is tuned.
ST: A stereo FM broadcast is tuned.
MONO: You have
monaural mode with [FM
MODE] to improve reception.
General display
Shows the input mode, radio
frequency, and
information.
[kHz, MHz]
Frequency unit indicators
kHz: AM, or PCM sampling frequency
MHz: FM
16
SA-XR45
)
SA-XR45
)
switched to
M
other general
)
POWER 8 ^
% DIGITAL EX
TUNED ST MONO
% DIGITAL % PL2 DTS 96/24 DTS-ES DTS NEO:6
2CH
SLEEP DIGITAL
MIX
ENHANCED
kHz
MHz SURROUND SFC
L C R
LS SB RS
S LFE