Advertisement
Installing the fan
All electrical work should only be undertaken after disconnection of the power by removing fuses or
turning off the circuit breaker to ensure all pole isolation of the electrical supply.
Your fan can be installed in either of two options. It can be installed as a flush mount fan (Picture B),
i.e. it is mounted as close to the ceiling as possible. It can also be installed as a drop rod style of fan
(Picture A). In this situation the drop rod assembly is used to lower the fan down from it's mounting
position slightly. Extension rods, ranging from 12" to 72" (your fan is supplied with 6" Drop rod in the
box), are available if you need to lower your fan further. (This is normally the case in conservatories
or rooms with very high ceilings.)
Picture A
Drop Rod Style
Picture B
Flush Mount Style
The following steps will guide you to a successful installation:
1.
Hanging bracket installation
2.
Down rod assembly style or flush mount assembly
3.
Attaching the blades
4.
Attaching the light plate and LED light fitter and glass
5.
Wiring instructions
1. Hanger bracket installation
Screw head >
spring
the ceiling and make sure all connections are secure to prevent the fan from falling. Fixings must
screw into a joist and not just the plasterboard. Loosen the two canopy screws from the hanger
bracket.
washer
>
round
washer >Hanger bracket > Ceiling. Screw the hanger bracket to
The hanger bracket should be screwed on to a firm flat
surface. The fixing location must be able to withstand ten
times the static weight of the fan. If you have any doubts as
to the ability of your intended fixing location to be able to
withstand this loading. Please contact our service help-line
or another competent authority to advise you. In most
situation two wood screws screwed into a wooden joist is
more than adequate to support your ceiling fan. The hanger
bracket should be screwed onto the joist with the two wood
screws provided. The washers provided should go in the
following sequence:
Advertisement
