now bring the active setpoint from the
Standard Circuit to the device.)
Figure 39 - Active Setpoints
23. Advance to the Inputs tab and repeat the
same procedure for converting the inputs
from a fixed value to a pointer.
24. The LIGHTS ON property input would
typically come from a time schedule as shown
in Figure 40.
Figure 40 - Lights On Output
Document Part # 026-4275 Rev 0
©2019 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emerson.com for the latest technical documentation and updates.
25. The Defrost Start property would be the
input pointed to from the Defrost Output
property from the Standard Circuit.
Figure 41 - Defrost Start
26. Advance to the Outputs tab. Only two
properties will be pointed back to the
Standard Circuit as shown in Figure 42.
NOTE: If the Standard Circuit Defrost Term Type property
was not set to Thermostat, the available DEFR DV TERM 1
will not display while executing
Figure 42 - Outputs Tab
REVIEW
The XM670K_50 Dual Compressor description file
was specifically made for OEM Carter Cases.
There are 2 Inputs and 2 Outputs connecting
between the XM670K_50 Device Application and a
Standard Circuit Application. See Table 1.
(LOOKUP)
.
Page 11 of 23