Table of Contents
Advertisement
Available languages
Available languages
GB
UNM 255-8-30 WXM Clean
Table of contents - Part 1
1.1
Scope of delivery ......................
1.2
Conventional use ......................
1.3
Technical data ..........................
1.4
Components.............................
1.5
Vessel inspections .....................
1.1 Scope of delivery
– Compressor with instruction manual
– Rubber dampers
– Documents accompanying compressed air
vessel
1.2 Conventional use
The compressor is designed for generating
and storing compressed air only. Com-
pressed air is only suitable for compressed
air tools/devices/machines.
Any other type of use is considered contrary
to the intended use.
The compressor must not be used in poten-
tially explosive areas. Combustible, caustic
or toxic gases must not be sucked in!
1.3 Technical data
see Fig. 1a
1.4 Components
01
Compressor unit
02
Intake filter
06
Connecting hose
07
Check valve
08
Vessel
I/2
09
Ball valve at condensate drainage point
10
Pressure switch with ON/OFF switch
2
11
Safety valve
2
12
Pressure gauge (vessel pressure)
2
13
Pressure gauge (working pressure)
2
14
Electric motor
18
Pressure reducer
2
19
Quick-action coupling (clean, regu-
lated compressed air)
23
Rubber dampers
30
Membrane dryer
31
Air cooler
32
Water separator with filter
33
Microfilter
34
Operating hours counter
1.5 Vessel inspections
Compressor with type test: Inspection is
not required prior to commissioning.
We recommend that a "qualified person" per-
form a pressure test on the vessel, depend-
ing on its rate of utilisation, after 10 years in
accordance with the Ordinance on Industrial
Safety and Health. Contact any of our service
partners.
It is essential to retain vessel documents
included in the delivery (= certification
documents) for the entire service life of
the vessel. The statutory specified inspec-
tions must be arranged in accordance
with the applicable regulations of the re-
spective country in which the vessel is
used.
Advertisement
Table of Contents
