Table of Contents
Advertisement
TM00358 Rev. A
4.5 HAND CONTROLLER INSTALLATION
Installing the Hand Controller
1. Pull and tag the main breaker to disable power and steering control to the turret.
2. Locate the turret's operator interface connection.
3. Insert the Hand Controller's communication cable in the connector. You many need to twist to align the guide
keys and then push in to complete the connection.
4. Tighten the Hand Controller's MIL-C-38999 threaded lock-ring to the connector. Stop when the red line on
the threads is no longer visible.
5. Restore power to the turret. The Hand Controller is now powered.
6. From the Hand Controller, lift up on the POWER switch and then push forward to turn the power on. The
turret is now powered.
L-3 WESCAM
All Rights Reserved
Chapter 4 - Hand Controller Installation
October 2007
83
Advertisement
Table of Contents
