Table of Contents
Advertisement
TM00358 Rev. A
Table 2-11 Status Information and Controls in the Level 2 Operator Gimbal Menu (Continued)
Field
ZOOM MULTIPLIER
ZOOM MULT. AZ. GAIN
ZOOM MULT. EL. GAIN
AZIMUTH GAIN
ELEVATION GAIN
AZIMUTH FWD
ELEVATION FWD
STEERING FLTR
AUTOSCAN
AUTOSCAN AZIMUTH
CENTER
AUTOSCAN ELEVATION
CENTER
AUTOSCAN WIDTH
AUTOSCAN RATE
AUTO NULL
FACTORY DFLT
DONE
L-3 WESCAM
All Rights Reserved
Values
ON, OFF
Enables or disables attenuation of steering sensitivity relative to the focal
length of the Video in Control. At wide focal lengths, less steering input is
needed for turret movement, while narrow focal lengths need greater input for
steering movement.
0 to 100
Alters the sensitivity of azimuth (horizontal) steering to slow camera panning
as the degree of zoom increases.
0 to 100
Alters the sensitivity of elevation (vertical) steering to slow camera tilting as
the degree of zoom increases.
0 to 100
Sets the responsiveness of horizontal steering movement.
0 to 100
Sets the responsiveness of vertical steering movement.
-179° to +180°
Sets the horizontal angle when the turret is in the Forward position. Customer
unique forward position is set to -90°.
±90°
Sets the vertical angle when the turret is in the Forward position.
0 to 100
Increases or decreases the responsiveness of steering controls. 75 is the
recommended setting.
Note: A value of 100 will disable steering.
ON, OFF
Initiates an Autoscan steering mode using the configured steering position,
sweep margins and sweep rate parameters.
-179° to +180°
Configures the horizontal angle for a sector scan.
± 45°
Configures the vertical angle for a sector scan.
1° to 90°
Configures the sweep width of a sector scan.
0.1° to 10.0°
Configures the sweep rate for a sector scan.
ACTION FIELDS
–
Resets the zero pressure steering reading and removes steering drift when
steering is stopped.
Note: When executing Auto Null, make sure you have no input pressure
applied to the steering controls.
–
Resets all user configured value fields to factory default settings.
–
Exits menu.
Chapter 2 - Operator Gimbal Menu
Description
October 2007
41
Advertisement
Table of Contents
