Table of Contents
Advertisement
TM00358 Rev. A
Table 2-2 Hand Controller Secondary Button Control Functions (Continued)
Item
Control
(4)
*MAP button
(5)
2X button
(6)
IR GATE button
(7)
STOW button
(8)
SCENE button
(9)
IR CAL button
(10)
POL button
(11)
*CNTRL AUTH
button
(12)
*TX button
* Optional functions. These controls will have no effect if the hardware or software features have not been integrated as part
of the turret system.
L-3 WESCAM
All Rights Reserved
• Press to enable Hand Controller steering control of a moving map cursor
position.
MAP
Note: Functionality depends on system integration. If you press the button
and cannot steer the turret, press button once more to regain steering
control.
• Press once to enable 2x E-Zoom for the IR sensor.
• Press twice to enable 4x E-Zoom for the IR sensor.
2X
• Press a third time to disable E-Zoom for the IR sensor.
• Press to toggle through gate size options.
IR
Note: Gate size samples an area of contrast level in an IR image. The
GATE
system software then applies the sampled level to balance the entire
IR image.
• Press to enable automated steering control of the turret to the Stow
position.
STOW
EOW & EON Sensors:
• Press to change scene type to compensate for high or low image contrast.
SCENE
IR Sensor:
• Press to change scene type to compensate for high or low image contrast.
Note: Scene will provide new parameters for video correction after a 1-Point
calibration is initiated. Press the IR CAL button after pressing the
SCENE button.
• For the IR sensor, press to initiate a 1-Point calibration.
IR
CAL
• For the IR sensor, press to change polarity of the video image from white
hot to black hot.
POL
• Press to transfer steering control authority in a multi Hand Controller
CNTRL
configuration.
AUTH
• Press to enable or disable MX-POD microwave transmission.
TX
Note: On some Hand Controllers, this button may have no label.
Chapter 2 - Hand Controller Controls
Description
October 2007
15
Advertisement
Table of Contents
