L3 Communications MX-15i Operation & Maintenance Manual page 90

Chapter 4 - Turret Service Stand Installation
Installing the Turret into a Service Stand
1. Remove the first foam layer.
2. Remove the service stand top plate from the case.
3. Remove each of the 4 service stand legs.
4. Remove the second foam layer.
5. Put the top plate on the turret. Align the 2 alignment pins on the lid of the turret with the alignment holes on
the top plate.
6. Install all mounting screws (1/4"-28 x 3/4") to attach the service stand plate to the lid
7. Tighten the first mounting screw. Use a bolt tightening pattern and tighten the second screw that is opposite
to the first screw.
8. Tighten a screw that is 90° from the first screw set, followed by the opposite screw.
9. Tighten all remaining opposite screw sets.
Note: 3 persons are necessary for the subsequent 6 steps.
10. Use 2 persons to lift the top plate and turret assembly out of the case.
11. Use a third person to put one of the legs into its respective mounting hole on the service stand plate.
12. Put a captive leg screw (114119-1.00-SS) into the hole, through the top plate and into the leg.
13. Do these steps again for the remaining legs.
14. Tighten all leg screws.
15. Put the service stand and turret on a flat surface.
16. At this time, the turret is prepared for aircraft installation or ground test.
17. Put the shipping foam into the case.
18. Attach the lid and keep the shipping case in a dry location.
October 2007
74
TM00358 Rev. A
of the turret.
L-3 WESCAM
All Rights Reserved