Figure 4-3 Orienting Alignment Pins - L3 Communications MX-15i Operation & Maintenance Manual

TM00358 Rev. A
Alignment Pin
WARNING: TURRET IS A HEAVY ITEM. USE ONLY APPROVED EQUIPMENT AND PROCEDURES FOR
UNPACKING AND LIFTING THE TURRET.
WARNING: SUPPLIED MOUNTING SCREWS FOR SERVICE STAND ONLY. DO NOT USE SERVICE STAND
MOUNTING SCREWS FOR INSTALLING THE TURRET INTO AN AIRCRAFT.
Caution: Do not over tighten mounting screws. There is no need to torque fasteners but do not exceed
100 in-lbs (11 Nm).
Unpacking the Turret Shipping Case
1. Move the turret's shipping case to an open area with a flat surface.
2. Make sure that the "This Side Up Arrow" is pointing upwards.
3. Undo the latches on the sides of the shipping case and remove the lid section.
4. Remove the top foam layer.
5. Lift the service stand top plate from the shipping case.
6. Remove the middle foam layer, service stand mounting screws and cap covers.
7. Inspect all foam pieces for water retention or material deterioration:
• If the foam has deteriorated, contact L-3 Wescam Customer Service for support.
• If the foam is moist or wet, place the pieces out so they can dry.
8. Make sure the turret remains in the bottom of the case until it is either installed onto a service stand or
aircraft.
L-3 WESCAM
All Rights Reserved

Figure 4-3 Orienting Alignment Pins

Chapter 4 - Turret Service Stand Installation
Cap Screws
(1/4-28 x 7/8)
Service Stand
Top Plate
Alignment Pin
October 2007
73