L3 Communications MX-15i Operation & Maintenance Manual page 6

Warnings & Cautions
AND SEAL.
• WIPE UP SUSPECTED CONTAMINATED AREAS WITH RYMPLECLOTH OR LENS
TISSUE MOISTENED WITH ISOPROPYL ALCOHOL.
• PLACE CLEANUP MATERIALS IN A DOUBLE PLASTIC BAG AND SEAL.
• WASH HANDS IMMEDIATELY AFTER CLEANUP IS COMPLETE.
• DISPOSE OF MATERIALS AS LOW LEVEL RADIOACTIVE WASTE PER LOCAL BIO-
ENVIRONMENTAL ENGINEERING OFFICE DIRECTIVES.
WARNING: TURRET IS A HEAVY ITEM. USE ONLY APPROVED EQUIPMENT AND PROCEDURES FOR
UNPACKING AND LIFTING THE TURRET.
WARNING: DANGER ZONE. THE TURRET IS REMOTELY CONTROLLED AND CAPABLE OF CONTINUOUS
MOVEMENT FROM DRIVE MOTORS THAT ARE CAPABLE OF FORCES THAT CAN INJURE
PERSONNEL.
Caution: Chips or cracks in turret windows are not air safe. If detected, contact an L3 Wescam Customer
Service representative.
Caution: Do not power wash the turret.
Caution: Never wipe a dry window with a dry cloth. Embedded debris will scratch the surface.
Caution: Never use tissues or paper towels. Such products contain abrasives.
Caution: Never allow wet windows to air dry as the surface will stain permanently. Do not start this
procedure unless you have sufficient time to follow all steps or while you are completing other
maintenance tasks.
Caution: Do not scrape bonded particles that cannot be removed with compressed air. Soak the
particles and allow them to loosen.
WARNING: ALTHOUGH INERT, THE NITROGEN GAS YOU WILL BE HANDLING IS COMPRESSED AND
THEREFORE SHOULD BE TREATED WITH THE CARE ANY COMPRESSED GAS REQUIRES.
REVIEW ALL MATERIAL SAFETY DATA SHEETS (MSDS) TO ENSURE SAFE HANDLING.
Caution: Turret's purge valve damages easily. Hang and isolate the supply hose to make sure the purge
valve does not bear the weight of the air hose and chuck. The purge valve could break off if the
hose is moved or kicked accidentally.
Caution: When purging, the nitrogen feed pressure should never exceed 0.35 kg/cm² (5 psi). Otherwise,
you risk damaging internal valves and other sensitive parts.
WARNING: DANGER ZONE. THE TURRET IS REMOTELY CONTROLLED AND CAPABLE OF CONTINUOUS
MOVEMENT FROM DRIVE MOTORS THAT ARE CAPABLE OF FORCES THAT CAN INJURE
PERSONNEL.
WARNING: DANGER ZONE. THE TURRET IS REMOTELY CONTROLLED AND CAPABLE OF CONTINUOUS
MOVEMENT FROM DRIVE MOTORS THAT ARE CAPABLE OF FORCES THAT CAN INJURE
PERSONNEL.
WARNING: READ DESICCANT MATERIAL MSDS. REVIEW THE MATERIAL SAFETY DATA SHEETS (MSDS)
SECTIONS FOR MATERIAL HANDLING, REACTIVITY AND MATERIAL DISPOSAL BEFORE
REPLACING ANY DESICCANT MATERIAL.
October 2007
iv
TM00358 Rev. A
L-3 WESCAM
All Rights Reserved