Video I/O Menu; Video I/O Menu; Figure 2-26 Level 2 Video I/O Menu; Table 2-10 Status Information And Controls In The Level 2 Video I/O Menu - L3 Communications MX-15i Operation & Maintenance Manual

TM00358 Rev. A

2.9 VIDEO I/O MENU

The Video I/O menu provides status information and various controls for managing video inputs and outputs.
Operators would use this menu to configure the device that accepts video inputs (monitor, VTR, VCR, mapping
computers) and video outputs (EOW, EON, IR). Operators can set which of the video displays that will be presented
with the overlay information. For security reasons, some recorded feeds may need to be set so the overlay is not
presented.

Table 2-10 Status Information and Controls in the Level 2 Video I/O Menu

Field Values
VIDEO
OUTPUTS
FACTORY DFLT
ALARMS
DONE
VIDEO IN IR, EOW,
CONTROL EON, OFF
L-3 WESCAM
All Rights Reserved
LEVEL 2 - VIDEO I/O
MODE
ALARMS
VIDEO IN CONTROL (VIC)
VIDEO OUTPUT
1
2
3
4

Figure 2-26 Level 2 Video I/O Menu

VALUE FIELDS
– Source:
• Sets the source and assigns a sensor to a video output channel.
Overlay:
• Enables or disables display of overlay graphics in video distributed to the output
channel.
ACTION FIELDS
– Resets all user configured value fields to factory default settings.
– Displays Alarms page with BIT test results for the Video I/O.
– Exits menu.
STATUS INDICATORS
Displays the current sensor that is the video in control.
OPERATIONAL
OK
EOW
SOURCE OVERLAY
VIC ON
VIC ON
VIC ON
VIC ON
FACTORY DFLT ALARMS DONE
Description
Chapter 2 - Video I/O Menu
October 2007
39