Safety Instructions; Warranty - M&C 70304G Instruction Manual

3

SAFETY INSTRUCTIONS

Follow these basic safety procedures when mounting, starting up or operating this equipment:
Read this operating manual before starting up and use of the equipment. The information and warnings
given in this operating manual must be heeded.
Any work on electrical equipment is only to be carried out by trained specialists as per the regulations
currently in force.
The installation and commissioning of the device must conform to the requirements of VDE 0100 (IEC
364) 'Regulations on the Installation of Power Circuits with Nominal Voltages below 1000 V' and must
be in compliance with all relevant regulations and standards.
Check the details on the type plate to ensure that the equipment is connected to the correct mains
voltage.
Protection against touching dangerously high electrical voltages:
Before opening the equipment, it must be switched off and hold no voltages. This also applies to any
external control circuits that are connected.
The device is only to be used within the permitted range of temperatures and pressures.
Consider IP-protection-class when choosing installation site.
Do not use the device in hazardous areas.
Installation, maintenance, inspections and any repairs of the devices must be carried out only by quali-
fied skilled personnel in compliance with the current regulations.
4

WARRANTY

In case of a device failure, please contact immediately M&C or your M&C authorized distributor.
We have a warranty period of 12 months from the delivery date. The warranty covers only appropri-
ately used products and does not cover the consumable parts. Please find the complete warranty con-
ditions in our terms and conditions.
The warranty includes a free-of-charge repair in our production facility or the free replacement of the
device. If you return a device to M&C, please be sure that it is properly packaged and shipped with
protective packaging. The repaired or replaced device will be shipped free of delivery charges to the
point of use.
www.mc-techgroup.com Temperature controller 70304G | 1.00.02 5