Table of Contents
Advertisement
13
CHANGE OF PARAMETERS
To change parameters the level inhibit on the user level has to be removed.
13.1 REMOVING AND ACTIVATING THE LEVEL INHIBIT
To remove the level inhibit, act as follows:
Standard display (below setpoint, up actual value ) has to be visible
•
Press key PGM and
•
display = Code 3 (all levels are locked)
Press PGM
•
Change value from 3 to 2 with key
•
The value is blinking after 2sec. and the change is taken over
•
The user level is unlocked now
•
EXIT
•
Press
To activate the level inhibit, act as follows:
•
Standard display (below setpoint, up actual value) has to be visible
Press key PGM and
•
display = Code 2 (all levels are locked)
Press PGM
•
Change value from 2 to 3 with key
•
•
The value is blinking after 2sec. and the change is taken over
The user level is locked now
•
Press
EXIT
www.mc-techgroup.com
simultaneously for 5sec.,
simultaneously for 5sec.,
Temperature controller 70304G | 1.00.02
13
Advertisement
Table of Contents
