Siemens CERBERUS FIT Series Operation (Short

www.siemens.com/buildingtechnologies
Operation (short)
FC120 Fire control panel (NL)
ALARM Procedure
with Alarm Verification Concept (AVC) Alarm Verification Concept (AVC) – suggested possible procedure – subject to local requirements
Fire alarm
Zone 1 Zone 1
Meeting room 1
3.
4.
5.
B
Action / Condition
1.
Press on the PMI
(V1) runs out (Password required)
2.
Read time of top line right side on the display top line right side on the display
3.
Read fire location on display.
4.
Go to the fire location.
5.
Decide: MAJOR INCIDENT
MAJOR INCIDENT:
A
Press
o
r actuate nearest manual call point.
B
Look at the LED indicator
'On: Fire brigade called'
'Off: Call fire brigade!'
(Remote transmission is switched off / not Remote transmission is switched off / not
available or defective)
Minor incident:
R
Press
(Password required)
6.
Press
7.
Press
Document ID: A6V10393200_a_en_--
2.
2:00 2:00
1/1 1/1
Go to the fire location. the fire location.
Decide:
MAJOR INCIDENT or MAJOR INCIDENT or Minor incident
.
before allowed before allowed reaction time
or minor minor incident incident.
<alarm delay off> <alarm delay off>
manual call point.
to reset the panel. to reset the panel.
twice.
twice.
ALARM-Procedure
Switching off detector zones
Switching on detector zones
Procedure in case of Fault
1.
R
Consequence / Status
Buzzer is turned off, alarm is acknowledged. Buzzer is turned off, alarm is acknowledged.
Countdown V2 for the investigation of the cause of alarm starts. 2 for the investigation of the cause of alarm starts.
Remaining time is shown as countdown before Fire Brigade call. Remaining time is shown as countdown before Fire Brigade call.
Information on the cause of ALARM Information on the cause of ALARM
If required, initiate suitable emergency measures. If required, initiate suitable emergency measures.
The remote transmission for fire alarm is activated immediately. The remote transmission for fire alarm is activated immediately.
ALARM is transmitted to fire brigade. ALARM is transmitted to fire brigade.
Fire brigade must be called by phone!
No automatic transmission to fire brigade No automatic transmission to fire brigade
–
Dial the following no.:
–
Fire detection system is in normal condition unless another event Fire detection system is in normal condition unless another event
occurs. It may be necessary to vent the room before resetting is occurs. It may be necessary to vent the room
possible. Elements that cannot be reset c possible. Elements that cannot be reset can be switched off
temporarily.
the evacuation.
Stop
the evacuation.
Start
Edition: 2013-07-24
Siemens Switzerland Ltd
Industry Sector
Building Technologies Division
International Headquarters
Gubelstrasse 22
CH-6301 Zug
subject to local requirements
A
phone!
Page 1
Page 2
Page 3
Page 4
7.
6.
1 / 4