Advertisement
Procedure in case of Fault
Step
1.
Press
on the PMI.
Read message/fault location on the display.
2.
Go to the fault location and remedy the cause of
Go to the fault location and remedy the cause of
3.
the fault.
4.
Press
on the PMI.
Figure 1
5.
Press
to reset the panel.
If you cannot eliminate a fault, please contact your service provider.
If you cannot eliminate a fault, please contact your service provider.
Document ID: A6V10393200_a_en_--
on the display.
Edition: 2013-07-24
Result
Buzzer on the panel is switched off.
is switched off.
Information on type and place of the fault.
Information on type and place of the fault.
When the fault has been eliminated, the system could be
When the fault has been eliminated,
acknowledged. The maintenance personnel is
ntenance personnel is called up if the
fault dialer is installed.
If activated, the local alarm equipment
the local alarm equipment is silenced.
The panel is in normal condition unless an event occur.
The panel is in normal condition unless an event occur.
4 / 4
Advertisement
