Cisco CGR1240 Replacing Manual page 5

Replacing FRUs in a Spare CGR Chassis
Detailed Steps to Replace the Chassis
Step 3. Replacing the Modules, N-Connectors, & Antennas.
Cisco recommends you to remove and insert modules to corresponding slots from the old chassis to the new chassis
in the following order:
1. Slot 3 module
2. Slot 4 module
3. Slot 6 module
4. Slot 5 module
Please note that the sequence of steps below is per module. Before attempting to remove or install any modules, please
ensure that you have the tools mentioned in the
The RF cables are connected to the Antenna/N-connector ports and assigned to slots as detailed in
Table 1
Antenna Ports
Slot
The ports are shown in
bottom upon following the swapping sequence.
Before You Begin
Port Assignment Table for Slots 3 & 4
3
3
Figure 6 and Figure 7. For the antennas, please pay attention to the part numbers listed on the
section.
4 5
4
5
Table 1.
6
N/A