Eizo DuraVision FDF2711W-IP Setup Manual page 22

*1 Can only be acquired when "IP Address," "Port," "Username," and "Password" are entered.
*2 If "Protocol" is "DirectUri," the "Obtain Camera Name" button is not displayed.
*3 This can be used only when displayed on the Web browser.
*4 When "Protocol" is set to "DirectUri" and "URI" starts with rtp://, the setting range will be 1024 to 65534.
*5 Can only be set if "Protocol" is "Panasonic" or "AXIS".
*6 Enter the username and password of the user who has the administrator's rights. For details, refer to the
network camera User's Manual.
*7 Can only be set if "Protocol" is "ONVIF".
*8 Can only be set if "Protocol" is "DirectUri".
*9 Only "RTP over UDP" can be set in the following situations.
• When "Protocol" is "ONVIF," and "Transmission Mode" is "Multicast"
• When "Protocol" is "DirectUri," and "URI" starts from rtp://
*10 This can be set only when "Protocol" is set to "Panasonic".
*11 Can only be set if "Protocol" is "AXIS".
Returns to the screen that shows a list of camera registration information in the step 3 above.
7.
Select "Apply".
A confirmation message is displayed.
8.
Select "OK".
Note
• If there is a failure in obtaining "Obtain Camera Name" or "Obtain Profile" information, the
following message is displayed. Check the settings again.
22
Setup