Eizo DuraVision FDF2711W-IP Setup Manual page 19

3.
Set the following items.
Network Settings
Item
IP Setting Method
*1
IP Address
Subnet Mask
*2
Gateway
*1 The initial address is "192.168.0.150".
*2 If the environment does not include a gateway, it is not necessary to set "Gateway". Either leave it as
default setting or set "0.0.0.0".
DNS Settings
Item
DNS
Primary Server Address
Secondary Server Address
NTP Settings
Item
NTP
Server Address
For entering methods, refer to "Entering characters" (page 16).
4.
Select "Apply".
The setting complete screen is displayed.
5.
Select "OK".
Detail
Select an IP Setting Method.
When "Manual" is selected under "IP Setting Method", "IP
Address", "Subnet Mask", and "Gateway" can be set.
Attention
• Avoid duplicate IP addresses for devices on the same
network.
• If multiple units of this product are connected on the
same network, their IP addresses should be changed.
Detail
(Only when "Manual" is selected under "IP Setting
Method" of "Network Settings") Set "DNS".
When "Manual" is selected under "DNS", set "Primary
Server Address" and "Secondary Server Address".
Detail
Set whether to use the NTP server or not.
When "On" is selected, set the NTP server address.
Setting range
DHCP / Manual
0.0.0.0 to
255.255.255.255
Setting range
Auto / Manual
0.0.0.0 to
255.255.255.255
Setting range
On / Off
Alphanumerics and
symbols
19
Setup