Loading The Lower Deck - Landoll 334C Operator's Manual

3-15.7 Connect winch #3 (See Figure 3-6) to
the next vehicle and pull it to the rear posi-
tion on the upper deck. (See Figure 3-9) Se-
cure with chains (See Section 3-17).
3-15.8 Unlock and raise the rear arm to an
adequate height to allow clearance for load-
ing vehicles on the lower deck (See Figure
3-10).

3-16 LOADING THE LOWER DECK

3-16.1 Make sure there is adequate clearance
between the upper and lower deck to load
vehicles on lower deck (See Figure 3-10).
3-16.2 If the approach plate is not already on
the ground, pull the trailer axles forward,
then tilt the trailer with the TRAILER TILT
CONTROL until the approach plate of the
lower deck touches the ground.
Figure 3-10 Preparing to Load the Lower Deck
3-15.9 Unlock and raise the front arm to an
adequate height to allow clearance for load-
ing vehicles on the lower deck.
3-15.10 Ensure that all arms are locked in po-
sition (See Section 3-12).
3-16.3 Free-wheel the winch cable from winch
#5 (See Figure 3-6) out until it is at the rear
of the lower deck so it is accessible after
loading the next vehicle.
3-16.4 Connect winch #4 (See Figure 3-6) to
the next vehicle and pull it to the front of the
lower deck as far as possible without inter-
fering with the upper deck. Secure with
chains (See Section 3-17).
3-15