Remote Control Operation - Landoll 334C Operator's Manual

3-11 REMOTE CONTROL OPERATION

3-11.1 The POWER SWITCH is located on the
top of the box and must be turned on for the
the remote control to operate (See Figure
3-4).
3-11.2 The EMERGENCY KILL SWITCH is a
button on the top of the box.
a. Should an emergency situation occur, the
receiver may be shut down by pressing the
EMERGENCY KILL SWITCH on the transmit-
ter. This must be pressed while the transmit-
ter power is in the on position.
b. To resume operation, the POWER SWITCH
must be turned off and back on again.
3-11.3
LOWER
UPPER
Figure 3-4 Remote Control
The DECK SELECTOR is in the middle
of the front panel. (See Figure 3-4).
When the deck selector is in this posi-
tion, the functions listed BELOW this
switch (Deck Upper Rear, U/C Travel,
and Trailer Tilt) are operational. For
the Front and Rear Winch controls, the
lower deck winches are operational.
When the deck selector is in this posi-
tion, the functions listed ABOVE this
switch (Deck Upper Front and Winch
Over Cab) are operational. For the
Front and Rear Winch Controls, the
upper deck winches are operational.
3-9