Preparation For Loading Procedure - Landoll 334C Operator's Manual

3-13 PREPARATION FOR LOADING PROCEDURE

WARNING
1. THE SEMITRAILER MUST BE COU-
PLED TO A TRACTOR AND THE LAND-
ING GEAR RAISED OFF THE GROUND
BEFORE OPERATING.
2. DO NOT OPERATE TRAILER HYDRAU-
LICS UNLESS TRACTOR BRAKES ARE
LOCKED.
3. DO NOT EXCEED THE GROSS AXLE
WEIGHT RATINGS FOR ANY AXLE ON
YOUR VEHICLE. THE COMBINED
WEIGHT OF THE TRACTOR, SEMI-
TRAILER, AND CARGO MUST NOT EX-
CEED THE GROSS VEHICLE WEIGHT
RATING (GVWR) OF THE TRACTOR.
Figure 3-6 Preparation for Loading
3-13.1
3-13.2
3-13.3
3-13.4
Practice all standard industrial safety
standards. Do not load any payload that will
overload any component of the trailer or
cause an unsafe condition.
Park the tractor/trailer in a straight line
on a level even surface. Set the tractor
brakes and release the semitrailer brakes.
(See Figure 3-6.)
Engage the tractor P.T.O. .
Move trailer axles all the way forward.
CAUTION
A STICKING SOLENOID VALVE WILL
CAUSE THE HYDRAULIC COMPONENT
TO OPERATE WHEN SWITCHING THE
REMOTE CONTROL ON OR WHEN RE-
LEASING THE CONTROL SWITCH FOR
THAT COMPONENT. IF THIS HAPPENS,
IMMEDIATELY HIT THE KILL SWITCH ON
THE REMOTE, AND REPAIR OR
REPLACE THE STICKING SOLENOID
VALVE.
3-11