Winch Controls - Landoll 334C Operator's Manual

3-9.6 The MANUAL LOCK CONTROLS (front
and rear arm locks) are the levers on the air
valves next to the Hydraulic control valves.
There is one for each of the deck tilt arms.
They have two positions.
LOCK Turn the lever counter-clockwise as
far as it will go. In this position, the
arm is locked and will not move up or
down. The control must be in this posi-
tion for remote operation. Activating
the REMOTE DECK TILT CONTROL
automatically unlocks arms.

3-10 WINCH CONTROLS

DANGER
1. THE WINCH IS NOT DESIGNED OR
INTENDED TO BE USED FOR LIFTING
OR MOVING PEOPLE. USING IT THIS
WAY CAN CAUSE SERIOUS INJURY
OR DEATH.
2. NEVER ATTEMPT TO DISENGAGE
THE WINCH CABLE SPOOL WHEN THE
CABLE IS UNDER TENSION. THE LOAD
CAN ROLL AWAY.
3. FAILURE TO LEAVE AT LEAST FIVE
WINCH CABLE WRAPS ON THE WINCH
CABLE SPOOL COULD ALLOW THE CA-
BLE TO COME OFF THE SPOOL.
3-10.1 The WINCH HYDRAULIC CONTROLS
(See Figure 3-2) are located on the hydrau-
lic control panel and the remote control (See
Figure 3-4). It is a three position control:
IN This position will cause the winch to
reel cable onto the winch spool when
the winch clutch handle is engaged.
CENTER This is neutral position. This position
will not operate the winch.
OUT This position will cause the winch to
reel cable off of the winch spool when
the winch is engaged.
3-8
UNLOCK Turn the lever clockwise as far as it
will go. In this position, the arm will un-
lock when the DECK TILT CONTROL
is joggled. Use this position only
when using MANUAL DECK TILT
CONTROL.
3-10.2 The WINCH CLUTCH (See Figure 3-3)
is located on the end of the winch.
IN In this position, the clutch is engaged
and the hydraulic winch controls will
power spool the cable in or out.
OUT In this position, the clutch is disen-
gaged and the winch will free-wheel.
To lock in the disengage position, pull
handle all the way out and turn a quar-
ter turn.
3-10.3 Operating the Winch
a. Disengage the WINCH CLUTCH when pull-
ing the winch cable out by hand.
b. Connect the hook to the vehicle and engage
the WINCH CLUTCH HANDLE.
3-10.4 Use the WINCH HYDRAULIC CON-
TROL to pull a vehicle onto the trailer or to
let a vehicle off of the trailer.
Figure 3-3 Winch Clutch