BENETEAU OCEANIS 46.1 Owner's Manual page 227

O PLATFORM:
PENING
1. Switch the circuit breaker.
2. Remove the guard-rails from the swimming ladder.
3. Push the switch downwards.
4. Wait for the system to stop completely.
Emergency Procedure
197837 RCD-2
Index C
1. Push the switch upwards .
2. Wait for the system to stop completely.
3. Replace the swimming ladder guard-rails.
4. Switch off the circuit breaker of the relevant apparatus on
the electrical panel.
If the cylinder fails, you can close the platform manually by following the steps
below:
- Shut off the DC supply of the cylinder by the circuit breaker;
- Remove the split ring (item 1) and the shaft (item 2) at the two cylinder fixings;
- Remove the platform cylinder and store it in the boat;
- Strike an end on the platform to raise it manually. It is possible to use a winch
for this operation.
C PLATFORM:
LOSURE
227
- When not operating:
- Make sure the breaker is turned off.
16 16