Page 2
Introduction The Adapta Table can be used in conjunction with a bed or a chair, and is ideal for reading, writing, using a laptop computer etc. It has two height adjustable tabletops, the larger of which is angle adjustable and has two lips to help prevent items slipping off the table.
Page 3
Parts Table top Table upright Table base 2 x Hex Bolt - M8x40 4 x Hex Bolt & Nut- M6x15 1 x Hex Nut - M8 2 x Spanner 1 x Knob - M8 2 x Washer - M8...
Page 4
Ensure that the ‘plate’ on the bottom of the table upright (b) is positioned in the direction shown. Step 1 Attach the table upright (b) to the table top 2. Attach using 4 x M6x15mm Hex Bolt and (a). Nuts. 1.
Page 5
With help attach the table base (c) to the Insert another M8 40mm Hex Bolt up table upright (b). through the table upright (b) and table base (c). Fix using a washer (6) and nut Place a washer (6) on the M8 40mm Hex (3).
Page 6
Table Adjustment • Remove all items from the table tops before any adjustments. • When adjusting the table height/angle, the table will drop unless it is supported. • Do not force the main table when adjusting the angle. Angle Adjustment Loosen the side lever (2 complete turns anti- clockwise).
Page 7
Care & Maintenance • The table can be wiped down with a warm damp cloth and mild disinfectant. Do not use hot water or abrasive cleaners as these can damage the table. • The wooden parts of the table top may be cleaned with a duster or dry cloth.
Need help?
Do you have a question about the Adapta RR07080 and is the answer not in the manual?
Questions and answers