Left Side Burner - Kenmore 700 Series Use & Care Manual

Left Side burner

□ Remove plastic packaging from side burner valve. Remove side burner grate from within
side burner shelf.
□ Connect flat igniter wire tip to the igniter pin on the side burner valve. (A & B)
□ Remove the 2 pre-installed screws from the valve control stem and set them aside. (C)
□ Loosen the side burner to insert gas valve. To loosen, remove the two screws on front bracket,
and loosen the rear bracket screws halfway. (D&E)
□ Insert the gas valve into the side burner (F), and insert the valve control stem through the hole
in shelf fascia. (I)
□ Replace side burner front bracket and tighten in place with 2 previously removed screws. (G)
Tighten screws on back bracket. (H)
Install previously removed 2 screws .Note:Do not tighten these 2 screws until the bezel is attached
□
to fascia and valve face.(I).
Attach bezel to facial and valve face with the installed screws .First attach one side key hole of
□
bezel to the screw ,then attach the other one to the other screw.Make sure the black mark faces
up.(J). Tighten the 2 screws .(K)
□ Push control knob onto side burner valve stem. (L) Replace side burner grate. (M)
□ Connect the round igniter wire tip to the pin on the white electrode protruding from the bottom
of the side burner shelf. (N)
24·146.03358410
A
C
E
B
D
F