ConvaTec Esteem synergy+ System How To Use

How to Use the
Esteem synergy+
System
With Pre-Cut or Cut-to-Fit Skin Barriers

Step 1: Getting off to a Fresh Start

Begin by cleansing the skin around your stoma with warm water.
Rinse and pat dry thoroughly.

Step 2: Getting the Right Fit

Measure the stoma and select the proper size Skin Barrier.
■ For Cut-to-fit Skin Barriers:
Trace the stoma size on the centre of the white release
paper on the back of the barrier, and cut an opening about
2mm larger than your tracing.
■ For Pre-Cut Skin Barriers:
Select skin barrier with pre-cut stoma opening slightly
larger than your stoma.

Step 3: Applying the Skin Barrier to Your Skin

Remove the central release liner from the back of the barrier and
place the opening over your stoma. place the opening over your stoma.
Press the skin barrier in place. Smooth the inner edge
closest to your stoma with your fingers, holding for 30
seconds to ensure a snug fit around the stoma.

Step 4: Applying the White Tape Border

If present, peel off the white release liner from the
Tape Border and press gently against skin, smoothing
out any wrinkles.