Table of Contents
Advertisement
3. Mounting and Wiring
● Poor contact might cause malfunction. Mount the module and connect cabling to the module
immediately after the module is unpacked so that dust or other foreign substances do not accumulate on
connectors.
● To avoid damaging a module when removing or mounting it, turn off the power switch of the power
supply module beforehand.
● To avoid damaging a module, observe the following precautions when mounting or removing the
module:
- Before mounting the module on the mount base connector, check that the connector pins are properly
aligned and not bent, broken, or soiled.
- Connecting or disconnecting a module that is tilted might damage connector pins. When moving the
module, hold it vertically parallel to the mount base as shown below.
Mount base
Notice
Bad examples
Module
3-2
Good example
Advertisement
Table of Contents
