Safety Instructions; Certificate Of Conformity Tr Cu (Eac Marking); Additional Instructions For The Atex Version; Flameproof Enclosure - Tecfluid CIP Series Instruction Manual

Table of Contents

Advertisement

8

SAFETY INSTRUCTIONS

The series CIP II of programmable totalizers are in conformity with all
essential requirements of all EC directives applicable to them:
2014/30/EU
2012/19/EU
2011/65/EU
Equipment for hazardous areas:
2014/34/EU
Declarations of conformity EC can be downloaded from the section "Downloads" of the
Tecfluid S.A. website.
8.1
Certificate of conformity TR CU (EAC marking)
Tecfluid S.A. have subjected the series CIP II of programmable
totalizers to a certification procedure according to the technical
regulations of the Customs Union of the Eurasian Economic Union
(EEU).
This Certificate is an official document confirming the quality of production with the
standards on the territory of the Customs Union, particularly regarding safety requirements
and electromagnetic compatibility.
9

ADDITIONAL INSTRUCTIONS FOR THE ATEX VERSION

This chapter only applies to equipment intended for use in explosive atmospheres.
9.1

Flameproof enclosure

These equipment conform with the directive 2014/34/EU (Equipment and protective systems
intended for use in potentially explosive atmospheres) as indicated in the EC-type
examination certificate LOM 14ATEX2006 X, LOM 14ATEX2008 X and its marking.
Given that this instrument belong to group II, it is intended for use in places likely to become
endangered by explosive atmospheres, but not in mines.
The category is 2GD, that is, it is intended for use in areas in which explosive atmospheres
caused by mixtures of air and gases, vapours, mists or air/dust mixtures are likely to occur.
9.1.1

Surface temperature

Equipment is certificated as Exd IIC T6.
The maximum possible surface temperature is 85ºC.
WARNING: RISK OF IMPACT
Because the housing is made of aluminium, the equipment must be installed and
operated always in locations at low risk of impact.
Electromagnetic compatibility directive (EMC)
Waste electric and electronic equipment directive
(WEEE).
Directive relating restriction of the use of certain
hazardous substances in electrical and electronic
equipment (ROHS).
Directive relating equipment and protective systems
intended
for
use
atmospheres (ATEX).
www.tecfluid.com
in
potentially
explosive
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cip ii

Table of Contents