Table of Contents
Advertisement
1. Preliminaries
See separate documentation for installation of ducts,
valves, etc.
INFO! The unit is designed for
indoor installation.
i
1.1. INSPECTION/MAINTENANCE
The unit must be installed with space for service and
fans and recovery system.
The control cable with plug for automatic control on top
of the unit must be easily accessible.
1.2. SPACE REQUIRED
Type
A
K2.1
335 mm
A: Space in front of unit
B: Space at side of unit
C: Space above unit
These are minimum requirements and only take service
needs into account. National statutory requirements for
electrical safety may deviate from this. Check which rules
apply in your country.
1.3. LOCATION REQUIREMENTS
The unit has been designed for location in the kitchen
over the cooker as it contains an integrated kitchen
hood. The unit is available in left or right versions
(exhaust air nipple to the left or right), depending on
what is the most favourable in relation to the duct
location.
B
C
2 x 2 m
215-380 mm
B=2mm
6
Filter
A=335mm
845mm
B=2mm
596mm
K 2 . 1
Advertisement
Table of Contents
