Connecting The Gas Supply - Hatco Krampouz KCMG Series Installation And Operating Manual

INSTALLATION

Connecting the Gas Supply

Gas Crepe Makers must be connected to an approved gas
supply line by an authorized and certified gas equipment
installer. Understanding the following information is required for
proper and safe installation.
• Verify that the unit is configured properly for the gas
supply—natural gas or propane. The specification label
indicating the gas configuration of the unit is located on the
bottom of the unit.
• Install the unit in a location with sufficient ventilation to
prevent the buildup of unsafe levels of noxious fumes.
• Make sure there is proper air flow around the unit for
combustion air. Do not obstruct the air ventilation openings
around the griddle or frame of the unit.
• Connect the unit to the gas supply piping using a moveable
gas connector that complies with ANSI Z21.69 / CSA 6.16
and a quick-disconnect device that complies with ANSI
Z21.41 / CSA 6.9.
• Make sure unit is installed with a dedicated gas shut-off
valve.
• Make sure a properly-sized restraining device is connected
to the restraining ring on the unit to prevent strain on the
gas connection. If the restraining device needs to be
removed for any reason, make sure that it is reconnected
before resuming operation of the unit.
Restraining Ring
Rear View, Model KCMG-1RCT
IMPORTANT NOTE
After shutting down a Gas Crepe Maker, a five minute waiting
period is required before relighting. This allows potential gas
buildup to clear.
8
English
Pressure Pressure
Regulator Regulator
3/8" NPT Fitting
Form No. KCMGM-1219