Philips FC8802 User Manual page 37

Problem Cause
The robot does The rechargeable
not start cleaning battery is empty.
when I press the
on/off switch.
The small plug is still
inserted in the socket
on the robot.
The robot does The dust container
not work and the compartment cover is
not present or is not
dust
compartment closed properly.
indicator lights up
continuously.
The dust container is
not present.
The robot starts The bumper of the
to move robot is stuck.
backwards during
cleaning or just
after it was
switched on. The
warning indicator
flashes quickly.
The warning One or both wheels
indicator flashes are stuck.
quickly.
One or both side
brushes are stuck.
The bumper is stuck.
The robot was lifted
while it was cleaning.
The robot does The bristles of one or
not clean both side brushes are
properly. crooked or bent.
The filter in the dust
container is dirty.
Solution
Charge the rechargeable battery (see chapter
'Preparing for use', section 'Charging').
The robot does not work on mains power. It only
works on its rechargeable battery. Therefore, always
disconnected the adapter from the robot and the
mains before use.
When the dust container compartment cover is not
present or is not closed properly, the robot does not
work as a safety precaution. Make sure you place the
dust compartment cover on the robot properly (see
chapter 'Before first use', section 'Inserting the
rechargeable battery').
Place the dust container in the dust container
compartment properly. Make sure you close the
dust container compartment cover properly.
If the robot manages to free its bumper by moving
backwards, the warning indicator stops flashing and
the robot starts cleaning normally. If the robot does
not manage to free its bumper, switch it off and lift it
so that its bumper comes free. Then switch on the
robot again.
Press the on/off switch to switch off the robot.
Remove the fluff, hair, thread or wire that is caught
around the wheel suspension.
Clean the side brushes (see chapter 'Cleaning and
maintenance', section 'Cleaning the side brushes').
Press the on/off switch to switch off the robot. Lift
the robot so that its bumper comes free.
Press the on/off switch to switch off the robot. Place
the robot on the floor. Then press the on/off switch
to make the robot resume cleaning normally.
Replace the side brushes (see 'Replacing the side
brushes' in chapter 'Replacement' and chapter
'Ordering accessories').
Clean the filter in the dust container with a brush
with soft bristles (see chapter 'Cleaning and
maintenance', section 'Emptying and cleaning the
dust container')
English
37