Page 2
FC8800/01 DISASSEMBLY- AND RE-ASSEMBLY ADVISE • First make sure that the appliance is unplugged. • Disconnect the connector and replace the wheel set. • To empty and/or replace the Dustbin assy (1), the Top Cover (4) has to be removed (see picture).
Page 3
FC8800/01 DISASSEMBLY- AND RE-ASSEMBLY ADVISE • To reach te inner parts for repair, the Top base (18) has • The PCB main (14) is a complete assy, and can be to be removed. replaced. A screwdriver can be used to remove the connectors.
FC8800/01 TROUBLESHOOTING This chapter summarises the most common problems you could encounter while using your robot. If you are unable to solve the problem with the information below, please contact the Consumer Care Centre in your country. Problem Cause Solution The robot does not start The rechargeable battery is empty.
FC8800/01 ELECTRICAL DIAGRAM IR, Drop down sensor (Front) IR, Bumper sensor IR, Top cover present sensor Buzzer LED, indicator B Main LED, indicator C LED, indicator A Left wheel PCB, Charge Right wheel IR, Dustbin assy Right side present sensor...