D.e.s.s. Key Programming - BRP SEA-DOO GTX LTD iS 255 Predelivery Bulletin

vmr2006-012-100_aen
B.U.D.S. is now ready to use. Refer to
KEY PROGRAMMING
The MPI-2 includes 2 status lights to show the
connection conditions: USB and CAN. Both lights
must be GREEN so that MPI-2 works properly.
vdd2006-001-151_b
If an "X" is shown in the status bar, it
NOTE:
means that no "ECU" is communicating with the
MPI.
mmr2009-020-001
Check the following:
– MPI protocol in B.U.D.S.
– Connections between the PC computer and the
vehicle.
If No vehicle detected... message box is dis-
played in B.U.D.S., refer to
TOOLS AND B.U.D.S. SOFTWARE
SHOP MANUAL
the appropriate
If Some of the information normally dis-
played... message box is displayed in B.U.D.S.,
COMMUNICATION TOOLS AND B.U.D.S.
refer to
SOFTWARE subsection in the appropriate
MANUAL .

D.E.S.S. Key Programming

The D.E.S.S. keys are color-coded to differentiate
them.
PREDELIVERY
D.E.S.S.
to complete procedure.
COMMUNICATION
subsection in
.
SHOP
D.E.S.S.
KEY TYPE
Normal key
Learning key
Rental key
Install a D.E.S.S. key, to be added or erased, on
watercraft D.E.S.S. post.
smr2009-035-005_a
1. Key to be added or erased
Briefly press start/stop button to power the ECM.
Engine must not crank.
Press the start/stop button every three
NOTE:
minutes otherwise the electrical system will shut
off.
Click on Keys tab.
smr2005-072-001_en
Adding a Key
Click on the desired Add Key button on bottom
of screen according to the type of key you want
to program.
2009-3
B.U.D.S. PROGRAMMING
COLOR
YELLOW or BLACK
GREEN
ORANGE
17 / 23