Husqvarna K 3000-Electric Workshop Manual page 32

19
?
32
WET SYSTEM
K3000 Wet
Construction
A spray nozzle is located on each side of the blade guard. The water strikes a
section of the cutting blade and the centrifugal force carries it out towards the
blade's diamond segments.
The spray nozzles have a smaller diameter for the water spray compared to
the petrol-driven cutters in order to restrict the amount of water.
Replacing the spray nozzles
Remove the screw.
Remove the spray nozzle.
Fit the right dimension
Check in the spares list that the
spray nozzle with the correct
dimension is fitted.
Light tightening
Tighten the spray nozzles with
moderate force.
K3000 Cut-n-Break
Construction
A plastic hose directs the water up to the nozzle which distributes the water
towards both cutting blades.
The wet system is accessible when the belt guards have been removed. See
page 27.
Replacing the spray nozzles
The intake is located with special screws
that direct the water to the spray nozzles
underneath.
Remove the screw.
Remove the spray nozzle.
Fit the right dimension
Check in the spares list that the spray
nozzle with the correct dimension is fit -
ted. The nozzles with several different
hole diameters are available depending on
the machine and application.
Light tightening
The spray nozzles have a thin material
between the outer and inner thread.
Tighten the spray nozzles with a light
force.