Preparations; Mounting The Battery Pack; Installing On The Camcorder - Sony PHU-120K Operating Instructions Manual

Preparations

Mounting the Battery Pack

Use this unit with a battery pack mounted.
The BP-U30 Battery Pack is recommended.
You can also use the BP-U60 Battery Pack,
but be sure to observe the following
precautions when doing so.
• Depending on the installation position,
this battery pack may interfere with
operation of the camcorder.
• The BP-U60 is heavier than the BP-U30.
If this unit should be dropped with the
BP-U60 mounted, the impact is greater
than when the BP-U30 is mounted.
Handle this unit with care, being careful
not to drop it or allow it to tip over.
Note
This unit does not have a recharging
function. Before mounting the battery pack,
charge it with the special BC-U1 or BC-U2
battery charger.
For information on how to charge the battery pack,
refer to the Operating Instructions of the battery
charger.
To mount a battery pack
Insert the battery pack into the battery slot,
and slide it in to lock.
To remove the battery pack
Keep the battery release button pressed and
slide out to remove.
Installing on the
Camcorder
Note
When installing this unit onto the
PMW-EX1, be sure to consult your Sony
representative.
Use the shoe adaptor and PHU connection
cable to install this unit on the camcorder.
Preparations 13