Bosch UniversalDistance 50 Original Instructions Manual page 25

Once the third measurement has been completed, the volume is auto-
matically calculated and displayed. The end result is shown at the bot-
24.589 m
tom of the display, while the individual measured values are shown
24.589 m
24.589 m
above it.
14866.9 m
3
Continuous measurement (see figure C)
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated every half a second. You can, for
example, move a desired distance away from a wall while reading off the current distance
at all times.
Select the continuous measurement function
Press the measuring button (4) to initiate the measuring process. Move
the measuring tool until the desired distance value is shown at the bot-
22.589 m
min
tom of the display.
24.589 m
max
You can pause the continuous measurement by pressing the measuring
23.000 m
button (4). The current measured value will be shown at the bottom of
the display. The largest and smallest measured value appear above it. Pressing the meas-
uring button (4) once more will start the continuous measurement again.
Continuous measurement automatically switches off after four minutes.
Deleting measured values
In any measuring function, you can delete the most recently recorded individual meas-
ured value by briefly pressing the on/off button (8). Repeatedly pressing the button
briefly will delete the individual measured values in reverse order.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the section on area measurement (see "Area measure-
ment", page 24).
Press the button (7) [+]. The calculated area is shown in the centre of
the display.
2.650 m
5.301 m
14.049 m
2
Bosch Power Tools
.
1 609 92A 4PE | (25.10.2018)
English | 25