Pentair Sta-Rite DIGITAL PT8 Instruction Manual page 15

BUTTONS STATUS
click!
hold
click!
3"
click!
3"
click!
3"
CHAPTER 5
OPERATIONAL CHARACTERISTICS
• Control of start-up for operation and
adjustable stop.
• • Integrated digital pressure gauge with
reading in bar and psi
• • Integrated pressure transducer.
• • Protection against dry running.
• By instantaneous absorbed current.
• • Protection against current
overintensity.
• • ART (Automatic Reset Test) function.
When the device is disconnected
ACTION
From status ON: device OFF.
From status OFF: the device starts operating and the
pump is activated until "Stop pressure With any of the configuration modes: valid the value introduced.
From status ON: device OFF.
From status OFF: the device continues operating until the
Display "Start pressure" for 3 seconds
We enter the "Start pressure" configuration.
Display "Start pressure" for 3 seconds
We enter the "Start pressure" configuration.
We view on the display the instantaneous current consumed. If we are viewing this, we then return to
see the pressure
setting of the nominal pump current
due to intervention of the protection
system following insufficiency of
water, the ART attempts, with a
programmed frequency, to connect
the device until restoration of the
water supply. See "ART. Automatic
reset function". It must be activated
in point 6 of the ADVANCED MENU (Ar1).
• • Rapid cycles alert: when the hydro-
pneumatic tank has lost too much
air, there are frequent start-ups and
stops. This alert is activated. It must
be activated in point 2 of the BASIC
MENU (rc1).
• • Manual reset button
.
• • 3 types of operation (differential,
reverse and synchronisation).
• • Control panel and 3-digit numeric
display, luminous led indicators and
buttons.
• • Possibility of configuration:
• • Stand-by mode.
• • Minimum rapid cycles time.
• • Connection and disconnection delay.
EN
13