Pentair Sta-Rite DIGITAL PT8 Instruction Manual page 16

EN
CHAPTER 6
STARTING UP
DANGER
Before starting up the device it is necessary to read the previous points, especially "Hydraulic System" and "Electrical
Installation".
Basic operational start-up consists of:
• 1. Start the device pressing
• 2. Introduce the nominal pump
current:
• Press
and hold for 3 seconds.
• We view on the intermittent screen the
nominal current with the ON led.
• Via the keys
and adjust the
nominal current indicated on the pump
plate. See Note 1.
• Press
to validate.
• 3. Introduce operating pressure:
NOTE 1
it is very important to introduce exactly the nominal current on the pump specifications plate.
BASIC PROGRAMMING MENU
• Press
+ for 5 seconds.
• Use the keys
or to modify the
values.
IT TYPE
BAR P
1
rc0 rc1
2
r.01 r. 99
3
Sb0 Sb1
4
ADVANCED PROGRAMMING MENU
• Press
+ + for 5 seconds.
• Use the keys
or to modify the
values.
14
• Press
• We view start pressure flashing and
the
• START ON led.
• Via the keys
start pressure from 0.5 to 7 bar.
• Press
• 4. Introduce stop pressure:
• Press
• We view on the screen the stop
pressure flashing and the STOP ON led.
• Press
the next one.
SYSTEM REACTION
It allows selection of the units in which
the pressure between bar and psi is displayed
Rapid cycles alarm:
- rc0: deactivated.
- rc1: alarm activated, when it is detected, a delay is produced in start-up to protect the pump.
- rc2: alarm activated, the pump stops when it is detected.
If the rapid alarm cycles are activated in the previous point (rc1), we can select the period of time between
3 consecutive start-ups, in seconds. We consider as rapid cycle between 1" and 99".
Allows activation or deactivation of the display standby mode (Sb1) (Sb0) to save energy.
• Press
the next parameter.
for 2 seconds.
and adjust the
to validate.
for 3 seconds.
to validate and to move to
to validate and to move to
• Via the keys
and adjust the
stopping pressure from 1 to 8 bar.
• Press
to validate.
• 5. I device remains configured and
ready for use.
• The sequence of parameters is as
follows:
DEFAULT
SETTING
bar
rc0
5 seconds
Sb0
• The sequence of parameters is as
follows: