On/Off Screen; Password/Language Screen; Menu Screen; Configuration Screen - Carrier Touch Pilot 30XW-V Manual

Message: All screens described below can display an information
message in the band at the bottom.
Message
COMMUNICATION FAILURE!
ACCESS DENIED!
LIMIT EXCEEDED!
Save changes?
HIGHER FORCE IN EFFECT!

4.4 - On/off screen

4.4.1 - Unit start-up
With the unit in Local Off mode, press
of operating modes. Select the required mode.
Shows the last
mode selected
Stopping the unit: press button
Confi rm the unit shut-down or return to the previous
screen.
8
Status
Equipment controller did not respond while
reading the table content.
Equipment controller does not allow accessing
one of the table data blocks.
The value entered exceeds the table limits.
Modifi cations have been made. The web
interface waits to confi rm exit by pressing Save
or Cancel.
Force or Auto command was rejected by the
equipment controller because the interface
force level is lower than the equipment
controller's level.
to display the list
Operating
mode list

4.5 - Password/language screen

①
② ⑤
1 Cursor showing the activated language
2 Logged in
3 Unit of measurement selection: Metric/Imperial
4 Enter the password
Logged off
5
ATTENTION: Validation of password only effective
after the log-in button has been pressed.

4.6 - Menu screen

To access the menu press button
Touch the required item to access the table/menu.
4.7 - Confi guration screen
① ②
1 Save
2 Cancel
3 Message
4 Previous page
5 Next page
③
④
③ ④ ⑤