Table of Contents
Advertisement
2.
Install O-rings (#11150332 & #1110318) in the grooves on the Bottom Intake
Assembly.
Ensure that O-rings are not twisted.
3.
Insert the SS Check ball into the Bottom Intake Assembly.
SS Check Ball must be inside the Bottom Intake
Assembly.
The configuration shown may damage pump.
4.
Push the Check Ball Retainer in ensuring the O-ring is no longer visible.
Bladder Reassembly:
1.
Install O-ring (#11150318) on the cap of the center tube weldment assembly.
Figure 4-9: O-rings on the Bottom Intake Assembly
Figure 4-10: Cap O-ring
16
Advertisement
Table of Contents
