Advertisement
Safty Information
Dear customer,
In choosing a TM R70/ TM Q70 model, you have decided to acquire a technically advanced table support system with crank adjustment. Your TM R70/ TM Q70 has been
manufactured inhouse with the utmost care and precision and has passed numerous quality and safety checks to ensure trouble-free and safe operation. You can significantly
contribute your long-term satisfaction with your TM R70/ TM Q70 model.
These safety warnings are important and must be complied with!
The inappropriate operation of the system can put people and property at risk!
Important Safty Information:
1.
Assembly and operation of the TM R70/ TM Q70 model must be in accordance with these assembly instructions otherwise there is a risk of injury!
2.
The table support is soley intended to serve the purpose of ergonomic adjustments for your desk in accordance with the weights and measurements given in these
instructions. Any usage other than that mentioned above is inappropriate; the manufacturer disclaims liability for any resulting damages. In such cases all risk is
carried by the user.
3.
Please also take into account the general legal and other regulations and legal provisions that are applicable including those that apply in the operator's country as
well as the applicable enviromental protection regulations. The regulations of trade associations or other supervisory authorities that are in force locally must always
be observed!
4.
The manufacturer cannot be held responsible for any losses or damage resulting from unauthorised modifications of the TM R70/ TM Q70.
5.
Store the Assembly and Operation Instructions close to the device.
6.
Do not leave children unattended with the table support. Children cannot estimate the danger of the force that the table support has.
7.
To avoid any danger of jamming or crushing it necessary to keep a minimum distance of 25 mm to the moving parts.
8.
The assembly site should be dry, dust-free and no direct sunlight.
9.
Power cables must not be pinched, bent, stretched or mechanically stressed!
10.
The socket for connection with the mains must be installed by a licensed electrician in order to avoid any hazard to persons or objects.
11.
In the event of a malfunction for example smoke, odors, unusual noises, or visible external damage switch off the system. Disconnect at the mains!
With attention of the provided guidlines, you will enjoy many years of satisfaction from your TM R70/ TM Q70. For any further enquiries please do not hesitate to contact us.
Cleaning recommendations for powder-coated surfaces
For optimal care and cleaning of powder-coated surfaces the following recommendations should be followed:
- Use only a soft cloth or industrial cotton wool. Refrain from rubbing hard.
- Surface and cleaning agent temperature <25°C. (Do not steam clean surface.)
- Clean slight staining with clear water (cold or lukewarm), small amounts of neutral or alkalescent detergent additives may be used, if necessary.
- Stubborn staining, such as greasy or oily substances, may require the use of benzene hydrocarbons which are free of aromatic compounds (test previously in a hidden surface).
- Do not apply detergent for extended periods of time. If necessary repeat cleaning process after 24 hours. Rinse well with cold, clean water immediately after cleaning. (Just use
a lightly damp cloth, nether wet!)
- Do not use scratching, abrasive agents.
- Do not use acidic or strongly alkaline detergents and surfactants.
Incorrect use or use otherwise than in compliance with this operating manual invalidates the warranty.
871100117 0000 Seite 3 von 10
Advertisement
